Ways to Change a Toilet: Do It Yourself Easy Steps Plumbing

De GEATI - Grupo de Estudos Avançados em TI
Ir para: navegação, pesquisa

Empty the toilet by flushing it while holding the toilet handle for some time to ensure it 5 Useful Steps for Dealing With Water Hammer Issues in Your Plumbing Pipes flushes longer than normal. In case it's not level, use some cents beneath it to level it. Thread the washers and toilet nuts on the toilet flooring screws. Tighten the nuts a bit individually while rotating from one nut to the other. Avoid over-tightening the nuts.

Utilize a hacksaw to cut off the exposed bolt part above the nuts. Next, apply ceramic tile caulk all around the toilet base while leaving the back area open to permit water to get out.

Step 6:

You can at this time connect the water tank. Some toilet storage tanks typically come along with a preinstalled fill as well as flush valves.

Nonetheless, if your toilet doesn't included preinstalled valves, you'll require to mount them yourself using the water container opening.

Tighten the spud nut on the threaded side of the flush valve. Next, put a spud washer over the valve spud nut.

Step 7:

If necessary, you can change the toilet fill valve.

Step 8:

Next, place the toilet valve inside the toilet container.

Then press the new valve shank downwards from the bottom while tightening its locknut with your hand.

Don't use any type of devices to tighten the nut. Strictly use your hands.

Step 9:

Lay the container on its back end. Thread a washer (rubber one) on each bolt. Insert each screw from within the water tank.

Next, thread one more washer (brass one) on the tank from below. Afterwards, thread a hex nut on the bolt from below.

Next, tighten them a 1/4 turn. Avoid over-tightening them.

Step 10:

Lift the water storage tank and also place it over the toilet bowl.

Position the spud washer over the opening and also put the bolts through the bolt openings.

Next, put washers on every screw. Start by putting a rubber-based washer. After that place a brass-based washer.

Next, insert a wing type of nut on every bolt. Tighten them all equally.

Step 11:

You can use a slotted screwdriver to support the toilet screws from the interior part of the toilet tank. Nevertheless, only tighten the toilet nuts and not the toilet screws.

You can press the storage tank a little bit on the side, rear, or front to make it level while tightening up the nuts with your hand.

Avoid over-tightening the nuts as this may damage the storage tank. Ensure the container is steady as well as level upon tightening.

Step 12:

You can now take care of the primary supply of water to the toilet tank.

Do this by connecting a new water tubing to the fill valve. Use the coupling nut that came along with the tube.

Allow water to flow by switching on the main water supply to evaluate for any leaks.

Step 13:

Finally, connect the new toilet seat.

Thread the brass or plastic bolts that came with the new toilet seat into the holes on the rim.

Attach the nuts from below as well as tighten them securely in place.

If these DIY steps are a little bit way too complicated or perhaps you would certainly like your toilet job done by a specialist.